BendRight

BendRight is a conduit-bending calculator built for working electricians. Not a classroom tool. Not a demo. Something you can actually pull out on a job site, in the dark, with dirty gloves.

The problem with most bending calculators: they use generic take-up numbers. Your bender is not generic. A worn shoe, a different brand, a cold morning - all of it changes where your bend actually lands.

BendRight fixes that.

Calibrate-your-bender first. You make one stub on your bender, measure it, enter it. The app learns the actual take-up for that bender and uses it from then on. Every calculation after that is matched to YOUR tool, not the textbook average.

When you're in the field, the number that matters goes up big in hi-vis yellow - the same multiplier mark you've been using since apprenticeship. Muscle memory doesn't need retraining. Below it, in small print, the precise centerline math so you can see why it works. Both numbers, right there.

Before you cut, hold your phone up to the wall. The AR camera overlay shows you the bend shape against the actual surface you're working on. Catch a clearance problem before you touch the conduit, not after.

9 bend types covered:
- Offset
- Stub-up
- 3-point saddle
- 4-point saddle
- Kick
- Rolling offset
- Back-to-back
- Segment bends
- Concentric bends

Each one has step-by-step procedures with action thumbnails. No hunting through menus. No reading a wall of text on a ladder.

No ads. No subscription. One-time purchase. Works fully offline - no signal required in the field.

Built by a Master Electrician, solo. Not a SaaS team that's never touched a bender.